Today I got my new horn through the mail and decided to put it on. I read the directions and it says you can wire it up to replace your factory horn. It is a small air compressor with tubes going to 2 Horns. I took the factory horns off and replaced them with the new ones. I cut the right horns wiring harness and it revealed 2 wires. (one which loops and leads to the 2nd horn on the left...like a circuit.) Since the Air compressor has a positive and negative I put the 2 lines on the positive (was going to keep one factory horn) and took my negative to the negative side of the battery. OK.... I told the wife to give it a little push and it sounded about a 1/16th of a second and quit...after that nothing. I checked the fuse labled HORN and it was fine. I took everything apart and replaced my factory horns, plugged the wiring harnesses back up and told my wife to push the horn while I held the wires together. No matter which way I held them nothing happened. If anybody has any suggestions please post them...

Thanks a lot!! Black (no horn) Tundra84

__________________

2007 Limited CrewMax 4x2
i-Force 5.7 V8
Sequential shift (console)
Red Rock Interior
22" Panther Rims
285/45 Nitto Tires
FlowMaster 40 Series Exhaust
Rockford Fosgate 800W
4- Focal Door Speakers
10 Inch Sony Flip Down DVD
Billet Grill Insert
Chrome Hood Accent
Billet Bumper Inserts
Stubbie Billet Antenna
Xenon Conversion Kit (Hi's and Low's)
Silverstar Fog Lights
Silverstar Park Lights and Turn Signals
Billet Gas & Brake Pedals
Blue Interior LED's
Blue LED's Underneath
Rainguard Vent Visors Smoke
Chrome Third Brake Light with TRD logo
Chrome Door Handles & Tailgate handle
Chrome Side Mirrors
Chrome Oval Step Tubes