Toyota Tundra Forum

My 2-way remote is kindda beat up and I might need a new one soon. Is programming a new remote as easy as opening the door, turning the ignition switch to "On", holding in the Valet/Program button, then pressing and holding the "lock" button on the remote at the same time?

Yes, the procedure is fully described in the LE Quick Start Programming Guide, first page.

__________________
-wleeb

You da man!

WOW! Wleeb, here it is 2:20 in the morning reading this novel on installing a remote start.
Your the man on this I have to admit.
Im not installing one, but Im appreciative of your replies to others that are.

__________________
2007 Tundra Crewmax, 5.7 liter, Limited 4x4
Fatbobs garage 3/1 Leveling kit,
20" MKW M26 wheels,
Nitto Grappler tires 305-55-20
WeatherTec front rear mats
Stampede bug guard

Thanks again Wleeb. I cut the bypass key and hooked up the glass break sensor. i ended up mounting it near the cig lighters, only deep in that cavity between the two. HEre's a pic.

Looks good syber, that deep it's virtually concealed.

He sure is. My hat is off to him for writing this post and detailing the instructions in pure detail with pics...

did you have any problems with the Xk05. I am installing a viper in a 2007 Tundra and the damn thing doesn't want to program

I had no problem with the XK05.
Here are a few things to check.

1. When you purchased the XK05 did you have it programmed for a 2007 Tundra?
2. Did you use the procedure below to program it for your key?

To Reset:

• Press and hold button and plug in module. LED comes on. When LED goes off, release button.

Vehicle Programming:

1. Connect the module and turn key to ignition position. LED will come ON solid; start vehicle.
2. LED turns off. Module is now programmed.
3. If the LED does not turn off, check all wiring and reset kit. Repeat steps 1 & 2

This is the wiring diagram I used, double check your wires. If the IMI wires are wired backwards it will not program. If everything checks out and the XK05 still does not program then try swapping the IMI wires

Hey Wleebster, are you adept at setting the alarm to valet mode?